 |
Model KE-1000 Mark 3
The KE-1000 Mark 3 Keyless Entry System provides reliable access control on new or existing elevators without engineering.
A single Keyless Entry key Pad may be used in an elevator in place of rows of key switches for restricting access to private floors. In fact Keyless Entry can be used anywhere key switches can be typically used.
|
Mark 3 System Uses:
- Inside the car restricting access to private floors
- At a landing, restricting access to the car
- At the main lobby, in a supervisor's panel
- In Hospitals, to initiate "Code Blue" Emergency Service
- In Nursing Facilities, to protect Patients
- In Luxury Condominiums, for Condo-Control
Mark 3 KEYLESS ENTRY systems use time tested, reliable solid state design. Key Pads use modern piezo technology and have no moving parts. Several attractive styles and finishes are available to harmonize with any architecture. The Mark 3 accepts codes from three to eights long. This allows users to choose easily remembered codes, and raises security to a high level with over 300 million selections.
|
 |
|
Installation is quick and simple.
With minor exceptions all wiring is local, requiring only one or two conductors in the traveling cable. A manual shipped with the system provides installation instructions and typical hook-up diagrams. All code circuits are factory pre programmed and tested using randomly selected codes that are recorded only in the Owner's Guide which accompanies the shipment. Pocket user's guides are available for turnover to the owner.
Typical System Mark 3 System includes:
|
 |
- One Essex Piezo TouchPad with green/red LED
- 15 ft. jacketed and shielded plug-in cable
- Master Control Module
- Drip-proof steel enclosure 8"x8"x2"
- Line switch with light indicator
- Power supply for 120 or 230 v, 50 or 60 HZ with voltage regulator and MDL 1/8 fuse
- Replaceable 9 v Nicad battery with trickle Charger
- Interface Board with Up to s daughter boards and relays (for up to 3 coded outputs)
- Relay contact rating 3a at 120 VAC
- Diodes for sneak circuit protection (included option)
- Screw Terminal Blocks for connecting elevator control wires and 120 volt 60 HZ line supply ground-pin connector socket for touch pad
- Slave Module with car systems requiring 4 to 6 coded outputs
- Service Touch Pad and 4-ft plug-in cable
- Installation and Operation instructions (1 per system)
- Owner's Guide (1 per system)
- User's Guide (Optional 10 per output)
|
|
Optional Features and Accessories:
- Timed (Automatic) Throw over or Keyless (Manual) Throw over to provide hours of unrestricted operation
- Factory installed Interface circuits for Otis Electronic Touch buttons
- Touch Pad Eleiminator where 5 or more call buttons are always restricted
|
|
